| SYMPTOM | POSSIBLE CAUSE | REMEDY |
| Zone light on or long Beeps on Arming. |
Zone detection device (eg. reed switch, movement detector) unsecured. |
Close door or window. Find cause of movement. |
| 10 beeps upon Arming. Mains light flashing - Battery light flashing. |
Mains power off. Battery low | Check plug pack is plugged in and power point on or call Installation Company. |
| 10 Beeps at any time (mains/battery light flashing) |
(as above) | (as above) |
| 1 long beep during keypad entry. | Invalid keypad entry. | Press ENTER button and reenter. |
| 2 second siren at end of exit time. | Zone unsecured before expiry of exit time. | Re-enter premises, disarm system, check zone isolate memory to determine zone at fault. |
| External strobe light Flashing. | Alarm occurrence since last arming of panel. |
Check Alarm memory to determine zone at fault. |
| Siren sounding when System disarmed. |
Tamper, panic or 24 hour zone, or Day zone activated. |
Reset alarm by entering code or activating key-switch, check panic buttons (if installed) or call Installation Company. |
| Armed/monitor light Flashing. | Monitor mode entered by mistake. |
Exit monitor mode. |
| Zone Excluded light Flashing. | A zone has been excluded. | Check zone excluded memory. Arm panel with all zones secured. |
| Tamper light flashing. | Tamper unsecured. | Call Installation Company. |
| Alarm memory light Flashing. | Alarm in memory. | Check alarm memory to see cause of alarm. |
| Cannot access Program Mode | - Panel Armed - Not using master code |
Disarm panel first before entering code To enter program mode: Press Prog - Master code Enter (see page 17 of manual) |